Crystal Luxe - Nano Ceramic Coating

Description

Driwe Crystal Luxe is a clear, nano-crystalline ceramic coating that protects automobile exterior surfaces from weather, chemicals, physical abrasion and UV rays while repelling water, dirt and other contaminants via a self-cleaning effect. Driwe Crystal Luxe applies a hard, inert, durable coating film that is up to several microns thick and imparts a deep, reflective shine. Driwe Crystal Luxe is a workhorse, quartz-based ceramic coating and will be the primary, go-to ceramic coating for most tasks.

TECHNICAL SPECIFICATIONS

Flash Point: 51°C | 124°F
Specific Gravity: 0.95 g/cm3 @ 25°C
Hardness: >9H (ASTM D-3363)
Thickness: 3 micron | 3000 nanometers
Adhesion: 5B – No Coating Loss (ASTM D-3359)
Temperature Resistance: 1200-1800°C | 2200-3300°F
Sliding Angle: 20-30°
Contact Angle: 100-110°

INSTRUCTIONS

• Shake well before use.
• Saturate a suede applicator (or similar applicator) with several drops of the coating from the dripper bottle.
• Apply the coating to a 3 × 3 ft section of the vehicle using a cross-hatch pattern with slight overlap to ensure even coverage.
• Allow the coating to dwell for 3–4 minutes at ambient temperature.
• Gently remove any excess product using a clean suede cloth or low-nap microfiber towel.
• Do not allow the coated surface to come into contact with water for 24 hours during the curing process. If water comes into contact with the surface, remove it immediately.
• For additional layers, wait at least 1 hour between applications.
• Do not apply the coating in direct sunlight or on a hot surface.
• Cure time may vary depending on environmental conditions. Test the product on a small, inconspicuous area first to determine the appropriate cure time.
• For force curing, either:
  • Cure in a booth at 60°C for 40 minutes, or
  • Use a portable short-to-medium wavelength infrared lamp for 10–15 minutes per section.

GENERAL INFO.

Cautions: Can cause eye irritation. Excessive inhalation may cause respiratory irritation. Ingestion can cause gastrointestinal irritation. Prolonged skin contact may cause slight irritation. Harmful if swallowed.

First Aid: If product comes in contact with eyes, flush with water for 15 minutes, call physician if irritation persists. If product is inhaled, remove to fresh air, call physician if irritation persists. If product is ingested, do NOT induce vomiting, call a physician.

TRANSPORT

DOT: UN 1993, PG III
IMDG: 5L
IATA: 10L